Hood design-Week 2

OBJECTIVE:      To Design the Back Door of a car by creating inner panel and outer panel with designing consideration and fix the reinforcements by Standards. INTRODUCTION: Back Door:      The trunk or boot is main storage of the car which is often a hatch at the rear of the vehicle. It also called tail gate. These doors…

OBJECTIVE:      Design and develop the essential flanges and reinforcement such as Front Roof Rail, Rear Roof Rail and Bow roof from given aesthetic surface. And do the curvature study and calculate Heat Distortion and snow load creation to determine and justify the position of Bow roof. INTRODUCTION: ROOF:      Roof is…

 FRONT FENDER DESIGN AIM:       To design a  front fender of a car by following the given master section as per the design considerations of OEM. INTRODUCTION:       Fender is the american english term for the part of an automobile, motorcycle or other vehicle body that…

Under-Body Coating: Definition :      Underbody coating is usually a dense cladding (often based on rubber) applied uniformly to the undercarriage of the automobile. It is normally sprayed or painted on when the car is just out of the dealership and is clean. But even if you are getting the undercoating…

BENCHMARKING : Definition :      Benchmarking in an automobile industry involves a structural comparision between similar products, services (or) processes on some dimension of performance.      It is a technical word of comparision. it's about a study of existing product. by doing a benchmarking we can sorting of a one…

DETERMINATION OF THE REGULATION TO THE GIVEN MODEL Objective:      Our aim is that maesure the clearance between fender edge and tyre. NX CAD software used to measure distance between them from given model and also conclude whether its satisfied European standards or not. INTRODUCTION: Fender:    …

AIM:       To Determine The Section modulus calculation and optimization OBJECTIVE:       Use section of the Hood and calculate the section modulus.       Vary the section in such a way that new section is an improved version of previous section. THEORY:      …

Aim :- To design a Hood outer panel, inner panel and the necessary reinforcements by the given Master section and design parameters. Theory :-  Hood is a main component of front portion of a car. It is an opening body panel that covers the engine in front engine vehicle. It consist of an outer panel and inner panel. The…

INTRODUCTION  A butterfly valve is from a family of valves called quarter-turn valves. In operation, the valve is fully open or closed when the disc is rotated a quarter turn. The "butterfly" is a metal disc mounted on a shaft. When the valve is closed, the disc is turned so that it completely blocks off the passageway.When…

Development of a Door Trim panel Aim:  Creation of CAD model considering CLass A surface, nominal thickness, and attachment features. Abstract: The project report explains steps and procedures followed while developing the Door Trim Panel of a car using CATIA V5. Using the CLASS-A surface and master sections…

AIM :- To create assemblies of Quick return mechanism and CV joint and to also create 2D drawing of the given assemblies in CATIA.   ASSEMBLY :- Assembly modeling is a technology and method used by computer-aided design and product visualization computer software systems to handle multiple files that represent components…

AIM Create the A Pillar Plastic component through the given Class-A surface and master section and perform Draft analysis. THEORY CLASS A SURFACE: Class A surface is a surface made by the designer specially in automotive design which is the aesthetic part of a body and is given as an input to the plastic designer to work…

 Objective:              The main aim of this challenge is to create a solid body of 'Door Trim Lower' with the help of the closed surface method by using the 'Generative shape design' workbench in CATIA V5. Performing the 'Draft Analysis' on the solid part body of the Door trim…

Dog house design for the Door Trim: Aim: Create the Dog House for the Door Trim considering the design rules and perform the draft analysis for class A and create the final close body component and perform the draft analysis. Objective: Create the Tooling axis  Design the class-B and class-C surfaces and join them. Use…