Hood design-Week 2
for the given input we firstly start to make the Inner panel for the given input file.
we made the offset for the outer paner with non-assosiative to outer part or we can go with anoter methord of making copy of input file and change the name of file and we have go to new and select the assembly. we have imported inner panel and outer panel when we have imported both file the they are on same co-ordinate we have firstly hide the outer panel .we start working on inner panel we made first fit the inner and outer panel then by tacking the offset of the given part
we made offset the boundary and trim with the surface for the same we have again made the offset the outer panel two time offset the outer panel boundary and trim according to the given master section we get the inner panel body and we have made the outline of the part. then we have started to made the emboss of the according to the our requirements firstly we made a sketch of the emboss on the datum and project the curve on the inner panel we have made the emboss for the sketch and then we have created the second emboss of various section according to the imagination of the design engineer and we have made the emboss and then we trim some slots on the emboss generally we have made the slots which create some space in the body & also we have provided the point to add mastic on the inner panel we have also provide the edge fillets to the emboss
then we start to provide the engineering feratures to the striker and hinges firstly we have made the datum at an angle to the datum to the referance datum we have provided the inclination to the datum we have get the link with weave geometry link and made the extend sheet for the output finally we have made the emboss with datum plane and we have also change the emboss of the datum system and select the datum which is created and finally we extrude the surface and made the face blend we have also provide the edge fillets to the emboss which are created by taking the referance to the datum
then we have thicken the outer panel of the given thickness and we have also give the assembly constrai according to the requirements .
then we start to work on the outer panel. In outer panel we firstly made the offset of the given input then offset the boundary and trim the msurface according to that we made the outer part as a hemming part finally we have creatd the offset curve on the surface and we create the line which extend the surface finally trim the sheet accoding to the drawing and made the part thick
after doing all of this we made the draft analysis of the part according to the desire axis then we get that it is good to go part
NOTE - for the attach file i am not able to open outer panel and inner panel at same time i have tried to clear the bug but i am not able to resole the issue according to the mentors instruction i have attach all file