Fender Design Challenge
FENDER DESIGN:-
OBJECTIVE- To design the car front fender with the help of using skin data given by styling team.
INTRODUCTION:
FENDER :- Fender is the US english term for the part of an automobile or other vehicle body that frames a wheel well.The purpose of the fender is to prevent sand,mud,rocks,liquids and another road spray from being thrown into the air by the rotating tire.Fender are typically rigid and can be damaged by contact with the road surface.
Here some fig,of fenders:
FIG.HALF BUMPER
Fender plays a major role in pedesterian safety while a car is in motion.when its in motion the wheel carryover the small stones,mud particle and theown away which may harm the pedesterians,so while designing these considerations are to be taken into account.
TYPES OF FENDER:-
1.Full bumper type
2.Half bumper type
Presently we are using the half bumper type, cause in full bumper the blank used for creating very large and also has lot's of wastage in half bumper type we have the possiblity of reducing the scrap.
There are 5 mounting reagion on the fender,they are
1.A-piller mounting
2.Body mounting
3.sill mounting
4.Bumper mounting
5.Drip mounting
GIVEN DATA.
DRIP MOUNTING AREA:
The area at which the fender gets attached to the engine housing through fasteners.
FIG. DRIP MOUNTING AREA
SILL MOUNTING AREA:
The are at which the bottom of the fender gets attaced to the floor of the near the bottom edge of the door.
SILL MOUNTING AREA
A-PILLER MOUNTING:
This mounting region is located near the cowl of the vehicle where the fender is fastened with the bottom edge of the wind shield.
FIG.A PILLER MOUNTING
BUMPER MOUNTING AREA:
Its located in beneath of the bumper. The fender gets attached before the installation of the bumper.
FIG.BUMPER MOUNTING AREA
BUFFLE MOUNTING AREA:
In this region,The buffle gets installed to the fender with the help of clips with holds the buffle with the fender along the wheel arch.
FIG.BUFFLE MOUNTING AREA
DIFFERENT VIEWS OF FENDER:
FIG.TOP VIEW FIG.RIGHT VIEW FIG.ISOMETRIC VIEW
CONCLUSION - The fender is design with the necessary mounting points considering the mounting parameters.