Design of backdoor

    Aim :         To develop the car Backdoor(Tail gate) with the reference of given skin data as per engineering standared by using NX12 Back Door :          The Back door is typically hinged, but sometimes attached by other mechanisms such as tracks, in front of an opening which is used for entering and exiting a vehicle. …

Question: For the Given Roof styling, create an ASSEMBLY by developing the essential flanges for the outer roof and creating the reinforcements. Provide appropriate dimensions and check for Draft analysis. Do a curvature study on the roof and perform calculations to determine the position of the Bow-roofs.…

Introduction to Fender: Fender is the part of the bedy of vehicle which covers the wheel and the engine compartment. The fender is provided in such a way that it will protect the padestrians from the high impact from the engine comapartment. The fender is also the cover made in such a way that the customer won't see the…

Aim Use the Section from your Hood design and calculate the Section Modulus using the formula    S = I/y. Objective:Use the Section of Hood design and calculate the section modulus using the formula S = I/yS = Section ModulusI = Moment of InertiaY = distance between the neutral axis and the extreme end of the object  Create…

AIM: To Design Hood outer panel, inner panel and the necessary reinforcements by following the Master section mentioned with the design parameter explained in the videos. Submit an assembly of Hood inner panel, outer panel, latch, hinge, and the reinforcements INTRODUCTION: HOOD: A car hood also referred to as a bonnet…