Creation of Multiple viewports, Scaling the drawing and setting in Template in AutoCad

1. Ans ,

AIM:

• To Create a layout of the Plan and Section A of the project using the template Tutorial-mArch.dwt in a scale as given in the Figure. Use the MV command to create the viewport of the size as shown in Figure. Also, use ATTEDIT command to edit the information in the title block. Use A1 size for the layout. Take a plot.
• Create a layout of the Kitchen drawn as shown in Figure. Use the scale as shown in the Figure. Use A4 Size page for the layout. Take a plot.

• Create a layout of the section and Use scale as mentioned in the Figure. Use MV command create multiple viewports. Take a plot.

Introduction :

• Draw the given diagrams plan, section , kitchen and industrial building section using Autocad command and make the layout for each diagram and take a plot.

Procedure :

Diagram 1 :

• Draw the given Plan and section of the building and make the plot using layout command
• In layout template command and press tutorial -march.dwt command to create the diagram outline of the diagram and make the edit of the blocks using Attedit command.
• Once enter it will end up in ISO A1 , which is size of the sheet
• Make the modelview in the layout byusing MV command and mark the plot for the view and make it scale of 1:50
• For both plan and section has to be ploted in the A1 sheet and make the scale of 1 :50
• Hence diagram drawn.

Diagram 2 :

• Draw the given Kitchen plan and make the plot using layout command
• Once enter it will end up in A4 , which is size of the sheet
• Make four MV to make the model view in all aspects
• Make the modelview in the layout byusing MV command and mark the plot for the view and make it scale of 1:2
• For kithcen crosssection which has to be of 1 :1 for the given cross.
• For zoom out paper PS.
• Hence diagram drawn.

Diagram 3 :

• Draw the given Secion of the industrial building make the plot using layout command
• Once enter it will end up in A4 , which is size of the sheet
• Make four MV to make the model view in all aspects
• Make the overall section modelview in the layout byusing MV command and mark the plot for the view and make it scale of 1:100
• For crosssection inner section which has to be of 1 :30 for the given cross.
• For zoom out paper PS.
• Hence diagram drawn.

RESULT :

• From the above procedure all diagrams are drawn proper dimensions and mensioned line style with proper allignment , All the diagrams are drawn using Layout, MV (Modelview), PS( Paper space), MS(Model space) and scale these are the some main command used in to draw the above diagrams.hence all diagrams are drawn.