Creation of Column Schedule and Drawing Template using AutoCad
q1
AIM: TO CREATE COLUMN SCHEDULE IN AUTOCADD SOFTWARE
OPEN AUTOCADD
COMMAND :QNEW
COMMAND: UNIT,
CLICK ENGINEERING AND INCHES
COMAND: LIMIT
SPECIFY FORST CORNER POINT :INTER
SPECIFY SECOND CORNER POINT: 50,50
COMAND :LINE
TAKE FIRST POINT
SPECFY 2ND POINT
AND MAKE RECTANGLE BY LINE TOOL
COMMAND :OFFSET ,SPECFY THROUGH DISTANCE
COMMAND: TRIM
COMMAND: MULTILINE TEXT
GO TO PROPERTY FOR ADJUSTING THE HEIGHT
COMMAND ED FOR EDITAING TEXT.
Q2
AIM: TO CREATE COLUMN SCHEDULE IN AUTOCADD SOFTWARE
OPEN AUTOCADD
COMMAND :QNEW
COMMAND: UNIT,
CLICK ENGINEERING AND INCHES
COMAND: LIMIT
SPECIFY FORST CORNER POINT :INTER
SPECIFY SECOND CORNER POINT: 50,50
COMMAND :LINE TOOL
SPECIFY FIRST POINT
SPECIFY 2ND POINT
AMD MAKE RECTANGLE
COMMAND: OFFSET
TO MAKE TABLE
COMMAND :MULTILINE TEXT
CLICK ON TEXT AND GO TO PROPERTY
ADJUST THE HEIGHT
Q3
AIM: TO CREATE NOTES SCHEDULE IN AUTOCADD SOFTWARE
OPEN AUTOCADD
COMMAND :QNEW
COMMAND: UNIT,
CLICK ENGINEERING AND INCHES
COMAND: LIMIT
SPECIFY FORST CORNER POINT :INTER
SPECIFY SECOND CORNER POINT: 50,50
SPECIFY FIRST POINT
SPECIFY 2ND POINT
AMD MAKE RECTANGLE
COMMAND: OFFSET
TO MAKE TABLE
COMMAND :MULTILINE TEXT
CLICK ON TEXT AND GO TO PROPERTY
ADJUST THE HEIGHT
Q4
AIM: TO CREATE WALL SECTION SCHEDULE IN AUTOCADD SOFTWARE
OPEN AUTOCADD
COMMAND :QNEW
COMMAND: UNIT,
CLICK ENGINEERING AND INCHES
COMAND: LIMIT
SPECIFY FORST CORNER POINT :INTER
SPECIFY SECOND CORNER POINT: 50,50
command :LINE TOOL
SPECIFY FIRST POINT
FOR 2ND AND THIRD POINT BY RECTANGULAR COOORDINATE METHOD
COMMAND : HATCH
FILLED THE SPECIFIED AREA BY BLOCK HATCH AND CONCRETE HATCH
COOMAND : QLEADER
MAKE THE DIMENSION
Q5
AIM: TO CREATE DRAWING SCHEDULE IN AUTOCADD SOFTWARE
OPEN AUTOCADD
COMMAND :QNEW
COMMAND: UNIT,
CLICK ENGINEERING AND INCHES
COMAND: LIMIT
SPECIFY FORST CORNER POINT :INTER
SPECIFY SECOND CORNER POINT: 50,50
COMMAND: LINE TOOL
SPECIFY FIRST PPOINT AND SIMILARLY 2ND POINT DRAW RECTANGLE.
COMMAND: OFFSET ,
CLICK THROUGH
MAKE HORIZONTAL LINE.
COMMAND LINE TOOL FOR VERTICAL LINE
COMMAND: TRIM, OFFSET.
COMMAND :SINGLE LINE TEXT AND DOUBLE INTER
CLICK ON TEXT GO TO PROPERTY
CLICK ON HEIGHT, ADJUST THE HEIGHT.
SELECT THE TEXT AND ADJUST THE LINE
COMMAND ED FOR TEXT.
