Creation of Column Schedule and Drawing Template using AutoCad

AIM-to draft the columns schedule using the line command and the font was taken ROMANS.shx wih text height taken as 8".

procedure

To draft the table line command and offset command used use suitable legths as i taken horizonatally 48' and 14' vetically.

Than TRIM command used to create the passages given in the question figure

now DT command taken and written all the text and placed at suitable positions

for columns rienforcement details circle and line command used and also annotate the bigger diameters in reinforcement shedule

Drawing 2.

Drafting the window schedule

A horizontal and vertical lines drawn with connecting each other orthogonally.

than make offset of both lines to make the table with equal distances execpt first column.

than DT Command used to type the text and give them the suitable height according to the space available.

font used Romans shx

Drawing 3

To create drawing templete Multiline text commamd used MTEXT

to write all the Notes

and than A rectangle drawn with the lines ouside of the text and offset the lines where needed

projection of all drawing are taken same to symmetry in the output file as you can see in AutoCAD file i attached

Drawing.4

draw the List of Drawing shedule

BY taken the Table command i draw the table of given Column and rows segments

Than type all the drawing information as given in the figure into the table.

Drawing 5

drawn the vertical line and offset it with lenth 9" and than make the horzonatl

lines to close from up and down sides

now the offset of horzontal line id made with suitable length at the sepration of hatching required

trimmed al un neccessary lines and for jog line at top and bottom

line drawn at midpoint and than offset both the sides

trimmed both side lines and creat the lines with the angle of inclinatioon required to connect both the lines

Now hactch command used and selected hatch as AIR-Con and line Hatch to hatch the same as given

Now qleader command used to give the annotation of available hatching as given in the figure