Creating various 3D Models like Furniture, Footing, Girder, Column drop with panel and Gable Wall in AutoCad
AIM- TO CREATE 3D FURNITURE ELEMENT AS SHOWN IN FIG ,BY AUTOCADD SOFTWARE.
COMMAND-QNEW
COMMAND -UNIT
SET THE UNIT
CLICK IN ENGINEERING AND INCH
COMMAND-LIMIT
SET THE LOWER AND UPPER LIMIT
CLICK ON WORKSPACE SWITCHING
CLICK ON 3D MODELING
CLICK ON ISOMETRIC VIEW
COMMAND- LINE
SPECIFY 2ND POINT AS
COORDINATE-( 2',0,0)
ASSUME WIDTH -2'
TAKE COORDINATE IN X,Y,Z DIRECTION
ABD SO ON....
Q2
AIM- TO CREATE 3D MODEL OF AN ISOLATED FOOTING AS SHOWN IN FIG ,BY AUTOCADD SOFTWARE.
COMMAND-QNEW
COMMAND -UNIT
SET THE UNIT
CLICK IN ENGINEERING AND INCH
COMMAND-LIMIT
SET THE LOWER AND UPPER LIMIT
CLICK ON WORKSPACE SWITCHING
CLICK ON 3D MODELING
CLICK ON ISOMETRIC VIEW
COMMAND-RECTANGLE
TAKE RECTANGLE AS PER DIMENSION GIVEN
COMMAND- COPY, DISPLACEMENT AS PER DIMENSION
COMMAN D- LINE
JOIN THE CORNER BY LINE
COMMAND. RECTANGLE
MAKE AT CENTER
COMMAND- MOVE
SPECIFIED HIGHT
COMMAND -LINE
ATTACH ALL THE CORNER
Q3
AIM- TO CREATE DROP COLUMN BY AUTOCADD SOFTWARE.
COMMAND-QNEW
COMMAND -UNIT
SET THE UNIT
CLICK IN ENGINEERING AND INCH
COMMAND-LIMIT
SET THE LOWER AND UPPER LIMIT
CLICK ON WORKSPACE SWITCHING
CLICK ON 3D MODELING
CLICK ON ISOMETRIC VIEW
COMMAND-LINE
AND MAKE BY RELATIVE RELATIVE COORDINATES SYSTEM.
Q4
AIM- TO CREATE 3D VIEW OF AASHTO TYPEE GIRDER BY AUTO CADD SOFT WARE
COMMAND-QNEW
COMMAND -UNIT
SET THE UNIT
CLICK IN ENGINEERING AND INCH
COMMAND-LIMIT
SET THE LOWER AND UPPER LIMIT
CLICK ON WORKSPACE SWITCHING
CLICK ON 3D MODELING
CLICK ON ISOMETRIC VIEW
COMMAND-LINE
AND RECTANGULAR COORDINATE SYSTEM.
Q5
AIM- TO CREATE 3D MODEL IF WALL BY AUTO CADD SOFT WARE
COMMAND-QNEW
COMMAND -UNIT
SET THE UNIT
CLICK IN ENGINEERING AND INCH
COMMAND-LIMIT
SET THE LOWER AND UPPER LIMIT
CLICK ON WORKSPACE SWITCHING
CLICK ON 3D MODELING
CLICK ON ISOMETRIC VIEW
COMMAND - LINE
PROCEED THROUGH RECTANGULAR COORDINATE SYSTEM.
