Creating Kitchen layout, Hatching of Architectural elements and sectional view of an Industrial Building in AutoCad

Aim: To Create the Kitchen Layout. Also, insert text wherever required.

All dimensions are in mm.

Procedure:

step 1: To draw Below Counter Plan

• Units are set to mm.
• Select line command and draw a line of 4300 in X direction and a line of 3200 in Y direction and complete the rectangle.
• Offset 230 towards all sides of the rectangle outside the figure.
• Offset of 600 from top of the room to draw the kitchen platform and otta.
• Give the offset as follows from left side 90 as first offset- 90mm as first offset, 1000mm for fridge, 600 for micro-oven, 450 for A1 part, 300 for A2/A3/A4, 900 for A5/A6/A7, and 300, 945 and 35 offsets.
• Offset 12 mm to both sides in each corner of the room.
• Offset 600mm from bottom in middle oF kitchen to draw platform.
• Now enter offset as- 900, 450, 900, 450, 450, 450, 560, 35.

RESULT:

PROCEDURE 2 - TO DRAW ABOVE COUNTER PLAN:

• Enter UN (units command) in command box and make the type as decimal.
• Select line command and draw a line of 4300 in X direction and a line of 3200 in Y direction.
• Offset 230 towards all sides of the rectangle outside the figure.
• Fillet all the offset edges.
• Offset of 600 from top of the room to draw the kitchen platform.
• Give the offset as follows from left side 35 as first offset and again the offset as 965, 600, 2595.
• Offset 12 mm to both sides in each corner of the room.
• Offset 350 mm from bottom in middle of kitchen.
• Now enter offset as follows-35, 450, 900, 900, 900, 1010, 35.

Hatching:

• To hatch type Hatch in the command box and select the internal points to Hatch.
• You can select different types of design of Hatch from the Ribbon..

RESULT:

Ans2.

AIM: TO CREATE ELEVATION AND HATCHING THE STRCTURAL AND NON-STRUCTURAL ELEMENTS OF THE BUILDING.

PROCEDURE

STEPS FOR DRAWING:

• Select line command and extend the lines from the plan.
• Offset 150mm from the ground level, 2450 for ground floor, 2850 for second floor,2850 for second floor, 2850 for third floor, 1000 for parapet wall, 2500 from terrace level for mumty, 450 from mumty for parapet wall of mumty, 600 and offset 1200 for O.T.H.
• For drawing of staircase offset 1250 for tread and offset 143.75 for rse of staircase.
• Offset 125 below floor level for slab.
• Draw the chajjas and windows as per the sizes.
• Give the dimensions by dim linear or dim continue command.
• Select the multiline text for naming of the section.

ANS3.

AIM: To create the section view of an industrial building.

PROCEDURE:

1. In the command prompt type L to draw the lines.
2. In the Ribbon bar -Hatch.
3. In the command prompt type rec to draw the rectangle.
4. In the command prompt type LT to get the dotted line.
5. In the command prompt type Mt to draft the text.
6. In the command prompt type c to draw the circle.
7. In the command prompt type dim to draft the dimensions.