Creating Kitchen layout, Hatching of Architectural elements and sectional view of an Industrial Building in AutoCad

AIM : TO CREATE THE KITCHEN LAYOUT AND ALSO USE PROPER DIMENSION AND TECHNIQUES TO DIMENSION THE KITCHEN LAYOUT

PROCEDURE

STEP 1

• unit are set in mm
• limits and limmax are also set
• zoom command is also used

STEP 2

• In the command type rec to rectangle and make rectangle of 4734 x 3688mm
• In command type offset to offset at distance of 230mm
• Using arc and lines to draw the doors and using hatch to hatch the figure
• In the command type rec to ,make fridge and given offset to make a micro oven
• In the command type offset to horizontal distance at 350, 450,900, 450, 450 and 560
• In the command offset and offset at 600 mm
• Use trim comand to trim the extra line
• Dimension command used to put dimension

AIM : TO CREATE THE ELEVATION OF THE PLAN WITH HATCH

PROCEDURE

• In the command type L for draw the line
• IN the command type rec to draw the rectangle
• Use arc command to draw arc
• Therefore the window is created
• Type L command for line
• Type rec for rectanngle
• At least make big triangle to make industry

AIM : TO CREATE THE SECTION VIEW OF AN INDUSTRIAL BUILDING

PROCDURE

• In the command type L to draw a line
• In the ribbon bar > Hatch > Ar .conc
• In the command type rec to draw rectangle
• In the command type LT to get the dotted line
• In the command type C to draw a circle
• type dim to dimension