Challenge

Creating 3D Isometric view of various structural elements in AutoCAD

1. Ans,

Diagram 1 :

Aim :

Introduction :

Procedure :

Draw the 2D plan of the building using line command and make it offset
Once the 2D plan drawn next one is elevation
Make the 2d plan to 3D view by changing view cube or by UCS command
Once changing it Make each part has to be selected example ( all wall parts are selected )
Make the command 'Boundary" and select the dropdown box to region and pick the points of the wall
All wall are region
Once the wall are region By using command Exturde to height the wall with given dimension
In window are using UCS command place the Coordinates along the window plane make the square along the window and extrude it
Make the window with proper dimension and layers has to be drawn along with the window
Once it is draw is placed on the wall using changing Coordinates UCS
And place the window
Hence the diagram drawn

Diagram 2 :

Aim :

Introduction :

Procedure :

Draw the 2D plan of the building using line command and make it offset
Once the 2D plan drawn next one is elevation
Make the 2d plan to 3D view by changing view cube or by UCS command
Once changing it Make each part has to be selected example ( all wall parts are selected )
Make the command 'Boundary" and select the dropdown box to region and pick the points of the wall
All wall are region
Once the wall are region By using command Exturde to height the wall with given dimension
In window are using UCS command place the Coordinates along the window plane make the square along the window and extrude it
Make the window with proper dimension and layers has to be drawn along with the window
Once it is draw is make a copy and placed on the wall using changing Coordinates UCS
And place the window
Hence the diagram drawn

Diagram 3 :

Aim :

To Create the ismoteric 3d view of a stair with railing as shown in the plan and elevation. Assume the
size of the balustrades and the hand rails.

Introduction :

Draw the 3D view of the staircase with hand rail By using Autocad 2d and 3d commands

Procedure :

Draw the 2D plan of the Staircase
Once the 2D plan drawn next one is elevation
Make the view cube in 3d and draw the staricase with riser and thread with standard dimensions
Once N number of steps drawn and placing lander at top of stair and make the bottom flight with given measurement
Once its drawn the All are selected and make the boundary options and make it region and extrude it
Draw the lines between the ends
Once staircase drawn then the handrail has to be drawn by placing ucs command on the face of the thread and make circle and make region and extrude it same of all
In the starting point of the staircase draw the circle vertical along hand rail extrude in path along the handrails placed
Hence the diagram drawn

Diagram 4 :

Aim :

To Create the 3D view of a Wall with spread footing . Create the Door opening only. Assume the size of
the parpaet and the coping. See the plans and elevation for the details.

Introduction :

Draw the 3D view of the Wall with spread footing By using Autocad 2d and 3d commands

Procedure :

Draw the 2D plan of the wall with all layers
Once the 2 d drawn change the plane and make it 3d view cube
Draw the wall along the spread footing with dimensions and also the parpet
Once drawn then Make region and extrude it
Then the view of the spread footing along with the wall is on the plane
Draw the door along the plane with center of the wall with proper dimension and make ucs command to draw it
Hence the Wall with spread footing is drawn

Results :

From all above procedure the given diagram are drawn with proper dimensions , These are some of the Main command used to draw the diagrams ( Line, Rectangle, UCS, Extrude, Boundary, Region, Layer etc...)Hence all the diagrams are properly drawn.

Ship work like this
in your own course.