Channel flow simulation using CONVERGE CFD

Introduction :  The main objective of this project is to show the flow through the Backward facing step. In this project we are going to use openFoam to run the set of programs inorder to see the result of Backward facing step. Here we are going to compare the results of different mesh grid and choose the best one…

Introduction: This project is based on setting up an Backward facing step flow using Converge CFD. The main objective of this project is to study the velocity profiles of a Backward facing block which is meshed by using different kinds of grid points. The changes in these grid points will be helpful to study the velocity…

Introduction: This project is based on setting up an channel flow using Converge CFD. The main objective of this project is to study the velocity profiles of a Block which is meshed by using different kinds of grid points. The changes in these grid points will be helpful to study the velocity profile and also to reduce…

Introduction : Nozzles are most commonly used in every field in order to study the liquid and air properties, because those two element plays a major role in engineering fields. However we may have many properties and the behaviour of fluids and air but we are still in position to find the exact solutions for the equations…

INTRODUCTION : The project is based on the solving a single equation in different iterations using different methods. As per the different methods equations are solved by their respective boundary and initial conditions. OBJECTIVE : The main objective of this program is to understand the temperature distribution over a…

  Link for the pendulum video. https://youtu.be/HFu0qDly-o0 Pendulum Function And Main program. function [theta_dot] = odefun_check_second_order(theta,t); theta_dot = zeros(2,1); theta_dot(1) = theta(2); theta_dot(2) = -theta(2)*0.5-(sin(theta(1)))*9.81; end clear all close all clc % time span % By increasing the…