Project Title: Internal Geneva Mechanism   Aim: To Create 3D models for driver and driven wheels using SOLIDWORKS.   To Perform motion analysis by rotating the driver wheel at 10rpm and 20 rpm respectively.   To Obtain the plots for: Contact force (between driving and the driven wheel) as a function of time.…

Project Title:  To run the motion analysis on the planetary gear with a sun gear, a ring gear, a carrier and four planet gears.   Aim: To access the gears from the toolbox in SOLIDWORKS present in the ANSI metric system. Provide the required parameters for defining each and every gear. Designing the carrier,…

Project Title: TO RUN A MULTIBODY DYNAMICS SIMULATION USING SOLIDWORKS ON A PISTON ASSEMBLY   Aim: To design the different parts of a cylinder piston arrangement separately. Keeping all the dimensions in mind clearly while designing. After designing all the parts, assembly is being done. One thing should be kept in…

AIM: In this project, the main objective is to model an IC engine valve train which consists of essential parts such as a cam, push rod, rocker arm, valve mount, and valve, then assemble them in SolidWorks.   Objective: To Run the simulation using the below parameters   SL.No. CAM Lift (mm) Speed (RPM) Material…

Objective:To create a solid model of a rotating flywheel on a shaft and identify 5 critical frequencies by generating 5 mode shapes using Solidworks Simulation’s Frequency analysis feature. Figure 1: Dimensions of the solid model created Tools used: Solidworks Simulation module Pre-requisites: A flywheel on a shaft…

Aim: In this Project, CFD analysis of the two-dimensional subsonic flow over a NACA 0017 airfoil at various angles of attack and compare the lift and drag force. The geometry of the airfoil is created using SOLIDWORKS. CFD analysis is carried out using Flow Simulation Wizard at various angles of attack from 0° to 10°…

Aim: In this Project, Creating a 3D model of a flowbench and run flow analysis where the internal flow takes place and running a baseline simulation and then performing a grid dependency test(4, 5 & 6) at a particular valve lift(0.003) and also performing valve lift(0.001 -0.008) test at a particular grid size(5).…

Aim: In this Project, Creating a 3D model of a Centrifugal pump, run a baseline flow simulation where inlet flow takes place and then perform a parametric study for different velocities. Showing the Performance diagram and Obtain the relationship between Pressure ratio and mass flow rate and explaining the results.  …