Wiring harness design in CATIA V5 - 3D modeling Week 5 & 6 Challenge

Answer01. Made the assembly of harness A and harness B as per the given geometry in Catia V5 using geometrical bundles and different connectors.

Bundle Continuity:- for the harness B , the main bundle has three sub brancable from the same branch point.

Below in snap it's showing the continuity of the bundle multi-branchable2 has Branchable.1 ,brachable.2 and so on.

Rsolved the error by adjusting the branch point

2.Annotation of the connector as per the layout below

3.Bundle Warnings:- While routing the bundle it would shows some error which was resolved by adjusting the connector position or branch point and addiing some slag percantage like 10%.

Error below

Error resolved by adjust the point in the right hand direction

Hence, the rounting is done without any errors in the catia v5