Wiring harness design in CATIA V5 - 3D modeling Week 5 & 6 Challenge
Harness A:
Given Input:
Connector-6
Defined electrically by defining connector, Bundle connection point and Connector connection point.
Connector-7
Defined electrically by defining connector, Bundle connection point and Connector connection point.
Connector-8
Defined electrically by defining connector, Bundle connection point and Connector connection point.
Connector-9
Defined electrically by defining connector, Bundle connection point and Connector connection point.
Connector-10
Defined electrically by defining connector, Bundle connection point and Connector connection point.
Connectors are routed using the Wiring harness Assembly.
i. Checking the bundle Continuity:
condition- True
All the Branches routed are in the connectivity
ii. Adding annotations to all the connectors:
iii. Check for the bundle warning:
Bundle warning appears due to the change in the position and orientation of the connector and the bend radius in the branchs. This can be resolved by positioning the connector w.r.t to the position of branch point and check the tangency contition while routing.
iv. Conversion of CATPRODUCT into the CATPART
Harness B:
Given Input
Connector-1
Defined electrically by defining connector, Bundle connection point and Connector connection point.
Connector-2
Defined electrically by defining connector, Bundle connection point and Connector connection point.
Connector-3
Defined electrically by defining connector, Bundle connection point and Connector connection point.
Connector-4
Defined electrically by defining connector, Bundle connection point and Connector connection point.
Connector-5
Defined electrically by defining connector, Bundle connection point and Connector connection point.
Connectors are routed using the Wiring harness Assembly.
i. Checking the bundle Continuity:
condition- True
All the Branches routed are in the connectivity
ii. Adding annotations to all the connectors:
iii. Check for the bundle warning:
Bundle warning appears due to the change in the position of the connector and the bend radius in the branchs. This can be resolved by positioning the connector w.r.t to the position of branch point and check the tangency contition while routing.
iv. Conversion of CATPRODUCT into the CATPART
Interconnection between Harness A & Harness B:
