Wiring harness design in CATIA V5 - 3D modeling Week 4 Challenge

                                                                          Wiring harness design in CATIA V5 - 3D modeling Week 4 Challenge

 

Q1. Route the following harness layout in Electrical workbench. Make assumption for harness bundle diameters. Use Following connectors as shown in layout diagram.

Add protective covering on all branches connected to DT06-2S & DT06-4S connectors. Keep end extremity at 30mm (from connectors end)

Download connector 3D data from www.te.com

• DT06-4S
• DT06-6S
• DT06-2S
• DT06-08SA

Ans) Here i create a wiring harness assembly by the application of electrical harness assembly workbench as per the given question. I follow the connector position as shown in above given layout diagram. 

  And also apply covering protection to main branch and it sub-branches connected to DT06-2S & DT06-4S connectors with keeping the end extremity at 30mm (from connectors end). Below the image of

  cad model of wiring harness assembly.