Wiring harness design in CATIA V5 - 3D modeling Week 4 Challenge
Route the following harness layout in the Electrical workbench
DT06-2S
First imported models from given link. open mechanical part design.
Defined the middle point with help of the mid point. On the connector side and bundle side.
Given axis system to connector side.
Rotated x-axis 90 degrees for y-axis coincidence.
Now changing the workbench electrical part design.
Defined as a connector with 2 terminations.
Then Defined the connector side as the connector connection point.
Defined bundle connection side as a bundle connection point.
DT06-4S
First imported models from given link. open mechanical part design.
Defined the middle point with help of the mid point. On the connector side and bundle side.
Given axis system to connector side.
Rotated x-axis 90 degrees for y-axis coincidence.
Now changing the workbench electrical part design.
Defined as a connector with 4 terminations.
Then Defined the connector side as the connector connection point.
Defined bundle connection side as a bundle connection point.
DT06-6S
First imported models from given link. open mechanical part design.
Defined the middle point with help of the mid point. On the connector side and bundle side.
Given axis system to connector side.
Rotated x-axis 90 degrees for y-axis coincidence.
Now changing the workbench electrical part design.
Defined as a connector with 6 terminations.
Then Defined the connector side as the connector connection point.
Defined bundle connection side as a bundle connection point.
DT06-08SA
First imported models from given link. open mechanical part design.
Defined the middle point with help of the mid point. On the connector side and bundle side.
Given axis system to connector side.
Rotated x-axis 90 degrees for y-axis coincidence.
Now changing the workbench electrical part design.
Defined as a connector with 8 terminations.
Then Defined the connector side as the connector connection point.
Defined bundle connection side as a bundle connection point.
Product
Open a new product file and imported all the defined models into it.
Manipulated all the models into the required positions.
Rotated all the connectors as required.
Made the main branch Bundle to bundle.
Create a Branch point with a distance of 100mm. with that point made a line with help of a point to direction.
created branch with help of line.
Now created Branch point distance of 100mm for sub branch.
A created line from the branch point with a direction of the connector y-axis.
all the branches are created with lines.
Made Cot for all sub-branches by maintaining a 30mm distance from the connector side.
Completed the challenge.