Wiring harness design in CATIA V5 - 3D modeling Week 4 Challenge

Q1. Route the following harness layout in Electrical workbench. Make assumption for harness bundle diameters. Use Following connectors as shown in layout diagram.

Add protective covering on all branches connected to DT06-2S & DT06-4S connectors. Keep end extremity at 30mm (from connectors end)

step 1 : creaating an new fie using the above way

step 2 : naming and saving the new product

step 3: Adding the existing component to the new product

step 4:making it as an geometric bundle

step 5:seperating all the components and placing it by using the compass

step 6:Positioning all the electrical connector components atthe appropritae place

step 7:Adding the branch with the electrical multibranchable

step 7(I) : Adding the branchable point to the main bundle

final output here the total output of the given modal is done..