Week 9 - Project - A pillar Design with Master Section

Report

In this challenge, surface quality was observed first using boundary. Then after creating tooling axis, draft analysis was performed.Then after clearing draft analysis, usual procedure of “offset” was performed and some patch filling to create final B surface. Then using “sweep, extrapolate and multi section” features the final A+B+C surface was created. Then it was created into a solid part using “closed surface”. Then using the mastersection, B surface features were created successfully and were added and union trimmed with the main body after performing draft analysis. And then final draft analysis of the entire part was done and it satisfied the standard parametres.