Week 9-Creation of 1D Connectors Challenge

Here's an example: Young's Modulus of steel is 210GPa which is input as 210e+9 in LS-DYNA as per SI unit system. However, if you use kg/mm/ms unit system, the input quantity will be 210. Thus the conversion factor is 10^-9. But, how? That's for you to find out in this assignment.   Value of the following measurements…

                           Assignment 2-RADIOSS Engine File Editing & 3D Meshing Challenge 1. Check the material properties of the rail component and calculate the speed of sound in steel rail=_______ First, we have to check the material properties…

                                                                        2D Meshing Challenge AIM       To extract mid-surface…

                                                                 Week 11 Car Crash simulation AIM          To run the Explicit dynamics…

                                        Week 10 Bullet penetrating a Bucket Challenge AIM          To run the Explicit dynamics analysis for Mechanism Bullet penetrating a Bucket on a total…

                                                         Machining with Planer Challenge   AIM          To carry out a explicit dynamics simulation…

                                            Week 9 Tension and Torsion test challenge AIM     To run the Explicit dynamics analysis for Mechanism on a total of 2 different cases with change in load…

                                                              Week 8 - Universal Joint AIM     To run the Transient structural analysis for  Mechanism…

                                                   Week 8 Worm Gear Challenge AIM          To carry out a transient structural analysis on Worm Gear with given…

                                                                      Universal Joint AIM        To run the analysis for Universal…

                                                                       Long Piston With Cam AIM       To run the analysis…

                                                                 Sphere pressing on a plate AIM          To carry out a…

                                                                          Wire Bending Challenge AIM         To…

                                                                            Rolling operation AIM        To…

                                                                 Sheet metal Bending challenge AIM          To carry out a static…

                                                                         Verification of Weld Joints Aim         …

                                                                           Railwheel and Track AIM      To carry out…

                                                                        Bevel Gear Challenge AIM      To carry out a static structural…

                                                                        Spur Gear Challenge AIM      To carry out a static structural…

                                                            Stress Concentration on a Plate with hole AIM       To perform static structural analysis to determine the stress concentration and total deformation on a plate with holes. OBJECTIVE       Design a plate with a hole model. (Case 1)       Design a plate with three…

                                                       Meshing of Rear Wheel Holder challenge AIM      To  extract a mid surface and mesh the  given component.  …

                                    Week 12:Project-1-Meshing of Door Inner Panel Challenge AIM       To extract mid-surface from given component by geometry clean up and create the shell (two dimensional) mesh…

                                      Week 9-Creation of 1D Connectors Challenge AIM      To create the 1D connection for given component. OBJECTIVE       Main objective of the given component is…

                                Week 8-3D Tetra Meshing Challenge AIM       To perform 3D tetra mesh or volume tetra mesh on the given models. PROCEDURE 1. MODEL         Create a Teramesh for Housing…

                                                                           Meshing of Hood AIM       To generate…

                                                       1D Element Creation Challenge  AIM:         Take a mid surface & mesh the given component &…

                                                                     Meshing on the suspension Assembly Aim:- Mesh the given rear suspension accordingly with 2D & Volume meshing as per the given quality criteria. Connections to be deployed for the model. Replicate the model symmetrically after all the meshing and connections.…