Week 9 - Challenge 2 - Switch Bezel Design

Hi,

PFA the CAT part with close surface.

Steps involved:

1. Identified the tooling direction by dummy Z axis.

2. Then created a tooling axis by bisecting which clears the 20 deg draft.

3. By using the surface commands and offset created the B surface.

4. Creating the C surface is a complicated one, as the Smooth curve option with the A surface support gives a non desireable output.

5. Created Different Boundaries on complicated areas and joined the C surface.

6. joined the A surface and C surface then Trimmed the B and joined Surface.checked for Boundaries, found few and cleared the Boundaries by different methods.

7. Made a close surface and checked for draft analysis

Please review and let me know for comments

Thanks

Gautham