Week 9 - Challenge 1 - Base Bracket Design
Week 9 - Challenge 1 - Base Bracket Design
Objective :-Create the Base Bracket Plastic component through the given Class-A surface. To begin with, the tooling axis for the given Class-A Surface should be created meeting the requirements of the draft angle and at the end perform the Draft analysis on the model.
Class A Surface
Draft Analysis In A surface
Tooling axis creation
- Interset the surface with YZ plane
- Make lines with coincidence with these Interseting Curves
- Make a line which bisecting with the lines that was over Tooling Axis
Class B Surface
CLOSED BODY
Isometric View
Front View
Side View
Top View
Draft Analysis
The minimum Draft Angle is 3°
Isometric View
Front View
Side View
Top View
