Week 8 - Challenge 5 - Door Trim Lower

Challenge 5 - Door Trim Lower

Aim: To create Door Trim Using Class A surface

OBJECTIVE :-

• Create the Door Trim Plastic component through the given Class-A surface.
• Thickness is considered as 2.5 mm
• Creating Tooling Axis.
• Performing Draft Analysis.
  • For Class A Surface 
  • For CLOSED PART 

 CLASS A SURFACE

this is a class a surface give we have first look for any discontinuities by simply using join or boundry fature .

 

checking Class A surface

Method 1 by using Join Feature if it is clear it will join or else shows the error

Method 2 by using Boundry Feature it will shows the gaps if there are any

TOOLING AXIS CREATION

for creating tooling axis we have to create point and create axis system on it

POINT CREATION

AXIS SYSTEM 

INTERSECTION 1

DUMMEY TOOLING AXIS 1

INTERSECTION 2

DUMMEY TOOLING AXIS 2

TOOLING AXIS

CLASS B SURFACE

OFFSET

LOOKING BREAKOUT PARTS

We can see there are many beakout surface after offset 

so we have to repair them 

REPAIRED CLASS B SURFACE 

CLASS C SURFACE

CLOSED SURFACE OF DOOR TRIM

PART BODY 

CLASS A SURFACE DRAFT ANALYSIS

PART BODY ANALYSIS

TREE STRUCTURE

DETAILED TREE STRUCTURE

PUBLICATIONS

CONCLUSION

DOOR TRIM IS CREATED USING CLASS A SURFACE,TOOLING AXIS CREATED DRAFT ANALYSIS DONE.