Week 8 - Challenge 3 - Coin Holder Design
Week 8 - Challenge 3 - Coin Holder Design
AIM:- To Create Coin Holder Plastic Component through given Class A Surface
Objectives:- To create Tooling Axis.
To Create Class B Surface.
To create Class C Surface.
To create Closed Surface and create Part Model
CLASS A SURFACE
TOOLING AXIS CREATION
For Creating Tooling Axis First we have to extract the Face on Which we are creating the axis and also we need to see for the correct tooling axis direction whether the part can be ejected by the Mould or not..
EXTRACT
Bottom face extracted and this face is taken as reference for creation of tooling axis
POINT CREATION
Tooling Axis
By using the line feature the tooling axis is creted.
CLASS B SURFACE
Class B Surface is created by extraction the Class A surafce and offset surfaces to 2.5 mm.
EXTRACT
following faces are Extracted
UNTRIM
Extracted faces are Untrimed to work on the Surface
EXTRAPOLATE
TRIM
by using Trim Operation the excess surface is trimed as reference to the Class A Surface
OFFSET
Offset value of 2.5 mm is given for trimed surface.
EDGE FILLET
While giving Fillet we need took for the Class A surface like that only the Fillet has to be Given.
For that We need To measure the Class A surface Fillet Radius.
Radius Measuring
extract
EXTRAPOLATE
OFFSET
TRIM
EXTRACT
EXTRAPOLATE
TRIM
CLASS B SURFACE
CLASS C SURFACE
EXTRAPLOTE
CREATE BOUNDRY FROM CLASS A SURFACE
SWEEP
CLASS C SURFACE
CLOSED COIN HOLDER
PART MODEL
TREE STRUCTURE
PUBLICATION
DRAFT ANALYSIS
