Week 8 - Challenge 3 - Coin Holder Design

ROOF DESIGN ASSEMBLY :-Therefore, we design the roof, front roof rails, front roof rails, center roof rails, and rear roof rails according to the master cross-sectional drawing, conduct moment of inertia and design analysis, and verify the feasibility of manufacturing.…

FEDER DESIGN :-  The main objective here is to design Drip area, Bumper mounting region, Sill mount region, A-Pillar mount region and Splash cover or wheel well mount regions for the given fender skin or styling surface.

Hood Design :- Hood is one of Door of vehicle which open and close the engine compartment , it is the engine cover with assembly of  outer pannel , inner pannel , hinges ,latch and strikker .                                   …

I have attached required files  

Underbody coating :- cars underbody is most prone to corrosion. Underbody coating provides long term protection from corrosion to car's underbody. It also protects parts like internal body panels, frame rails and other inner cavities that are not physically accessible but are prone to corrosion.   …

BENCHMARKING :-The functional benchmarking of the drivetrain includes the determination of the driving resistances and of the energy consumptions as well as the analysis of the vehicle range for different standardised driving cycles. PASSENGER CARS FOR Mr. D.S. Pughazhyendhii1)- Maruti Suzuki Baleno :- It…

DRAFT ANALYSIS ;- draft analysis technique is used to analyze whether our part model created in CAD is manufacturable based on the draft condition applied. Here the part should get easily removed from the panel dies (in case of Sheet metal part) or Mold . TOLLING AXIS :- The direction in which the mold or…

DRAFT ANALYSIS :- THE ANALYSIS IS USE TO NOGOTIATE THE UNDERCUTS FROM FINAL PART AFTER MOLDING . TOOLING AXIS ;- IT IS USED TO ANALYSIS OF DRAFT FOR ANGLE OF DRAFT TACKING TO LIFT OUT THE JOB FROM CAVITY. BISECTING METHOD :- BY USEING IT WE CAN CREAT NORMAL TOOLING AXIS TO THE GIVEN CLASS A SURFACE AND JOB WILL SAFE IN…

DRAFT ANALYSIS :- DRAFT ANALYSIS IS THE FEATURE USED FOR ANALYSIS OF EGNORING THE UNDERCUTS OF RESPECTIVE PART . TO MAKE PART WITHOUT DEFECTS .TOLLING AXIS :- ITS AXIS WHICH IS MUTUALY PERPANDICULLAR TO THE PART WHICH REALISE THE TOLLING DIRECTION OF THE PART . WE CAN TAKE IT FROM BISECTING OF TWO SIDE OF THE PART BODY