Week 7 Challenge

FOR THE FOLLOWING DOOR BEZEL MODEL, THERE IS AN UNDERCUT PRESENT IN THE MODEL.NOW I AM CREATING SLIDERS FOR THE CORRESPONDING MODEL 

• FIRST STEP IS THAT THE AREA WHICH WE NEED THE SLIDER
• SECOND STEP IS THAT TO CREATE THE PATTERN OF SLIDER TO COMPLETE THE MOULD
• THRID STEP IS THAT TO CREATE THE GUIDE RAILS FOR THE SLIDERS TO MOVE BACK AND FRONT FOR THE SLIDER MOTION
• FOURTH STEP, TO PROVIDE STOPPER FOR THE SLIDER 
• FIFTH STEP IS THAT TO PROVDE PROPER CLAMPING FOR THE GUIDE RAIL
• FINAL STEP IS THE TO CHECK THE SLIDER POSITION ALINGMENT AND SO ON 

THE FOLLOWING FILES ARE ATTACHED BELOW