Project 1

FROM THESE TABLE FAN CASING MODEL GIVEN, I HAVE JUST CREATED THE CORE AND CAVITY BLOCKS AND SLIDERS FOR THE RESPECTIVE MODEL GIVEN

THIS MODEL IS COMPLICATED,WHERE IN THE PREVIOUS MODEL I HAVE CREATED THE CORE CAVITY ONLY WITH CORRESPONDING TO THE MODEL FEATURES.WHEREAS IN THIS MODEL THERE IS AN UNDERCUT IN THE MODEL.ACCORDING TO THE MODEL INSTEAD OF CORE AND CAVITY WE HAVE TO CREATE SLIDER IN THE MOULD TO ATTAIN THE PART GIVEN. THA FOLLOWING PROCDURE ARE SET TO FOLLOW

• FIRST STEP IS THAT OPEN THE GIVEN MODEL IN SOLIDWORK AND DRAFT ANALYSIS
• SECOND STEP IS THAT INCRESING THE SCALE VALUE FOR THE MODEL WITH RESPECT TO SHRINKAGE VALUE FOR POLYMER
• THIRD STEP IS THAT CREATING PARTING LINE AND SHUTOFF SURAFCE
• FORTH STEP ONCE THE SHUTOFF SURAFCAE CREATED MEANS THEN CREATE PARTING SURAFACE
• FIFTH STEP IS THAT CREATING SEPARATE CORE AND CAVITY SHAPE FORMATION
• SIXTH STEP IS THAT CREATING SEPARATE CORE AND CAVITY SOLID BLOCK WITH THE HELP OF PARTING SURFACE CORE CAVITY SURAFACE
• SEVENTH IS THAT ACCORDING TO THE MODEL WE HAVE TO CREATE A SLIDER FOR THE RESPECTIVE MODEL
• EIGHT STEP IS THE CREATING SLIDER BLOCK WITH RESPECT TO SHAPE THAT WE TO ATTAIN
• AFTER CREATING THE SLIDER FOR THE GIVEN MODEL CREATION EJECTOR PINS IS MORE IMPORTANT
• THEN CREATE EJECTOR PINS
• AND SO ON