Challenge

Week - 4

Implement control logic of a “washing machine” using Stateflow as per given sequence:

Aim:

To Implement control logic of a “washing machine” using Stateflow as per given sequence.

Explanation:

Open a simulink workspace and open the flowchart and insert power,water,soaking,rinsing,drying,end blocks and connect them with the corresponding values.
Add constant block and mention the values of 1 and 1 for power and water supply.
Add slider switch and connect them with power and supply to on and off.
Set the soaking time as 200s and washing time as 100s.
Once the power supply is on the system will get activated.
The rinsing will be happens on 20s and dryers should be run for 50s.
Then open the modeling and click the symbol pane.
Then select the Power and water as the input and rest as the output.
Once finish connect all the inputs and outputs to the display.
Then connect the display to the light and indicate them in two colours red and green.
Once the water and power is turned on the sydtems starts to run and we can see the outputs in the light.

Result:

Therefore the control logic of a washing machine has been implemented.

Aim: To make a simulink chart for the Gear Shaft.

Explanation:

Open a simulink workspace and open the state flow.
Insert the state flow for various gears as Gear 1,2,3,4,5.
Enter the value for various gear as entry:g=1, as upto 5.
Then set the speed range for various gear 1,2,3,4,5.
Then enter the input as speed S and output as gear G.
Insert the slider gain and connect them with a constant block.
Then connect the slider gain into the flow chart.
Then open the modeling and symbol pane and set the input as speed and the output as gravity.
Then connect the gravity to display.
Then run the program to see the output to confirm the stateflow.

Result:

Therfore the control logic of a washing machine has been implemented.

Ship work like this
in your own course.