Week 3 - Solving second order ODEs

AIM-  To Write a code in MATLAB to optimise the stalagmite function and find the global maxima of the function.   Theory- Genetic Algorithm (GA) is a search-based optimization technique based on the principles of Genetics and Natural Selection. It is frequently used to find optimal or near-optimal…

    Aim:-  To solve an ordinary differential equation (ODE)  and use the calculated information to animate the motion of the pendulum via MatLab.   Introduction:- Pendulums have many applications and were utilized often before the digital age. They are used in clocks and metronomes due to…

                                            SIDE POLE CRASH SIMULATION OF DODGE NEON CAR                                 Project 2…

                                                          FRONTAL CRASH SIMULATION OF DODGE NEON CAR                    …

                                                            Assignment 5-RADIOSS Interfaces & Study of Effect of Notches Challenge   AIM :-  Create…

    OBJECTIVE: Through this challenge, we will study different material laws in Radioss and will select the best material law for the given scenario by simulating and plotting graph. PHYSICAL PROBLEM DESCRIPTION:-                          …

Objective The goal of this assignment is to compare the results of the simulation of a beam against a rigid wall with two different 2D element formulations.   Base Simulation Step 1: Loading the model The base file is loaded into Hypermesh and the model can be observed as shown below.        …

  OBJECTIVE: 1. Check the material properties of the rail component and calculate the speed of sound in steel rail 2. The length of the rail is about 1000 mm. calculate the time takes for a shock wave to travel from one end of the rail to the other. 3.Time for sound to travel the length of the rail…

    PRACTICE MODELS MESHING OBJECTIVES :    To          Clean the geometry.     Extract midsurface.     Clean midsurface geometry.     Ignore holes less than dia 5mm.     Create 2D mesh with target length 5mm, min 3.5mm max 7mm.  …

                                                                                           …

                                                                      VOLUME MESH GENERATION AND DEPLOYING CONNECTIONS FOR CAR REAR SUSPENSION  …

                                                           PREPROCESSING OF INSTRUMENT PANEL (IP) OR DASHBOARD OF CAR USING ANSA            …

    AIM        To practice all the morphing techniques with the given component.   MORPHING       A method for changing the shape of a meshed surface while preserving the topology. Only node positions are updated. The basic idea of mesh morphing is to…

                          CONNECTIONS REPRESENTATIONS OF REAR DOOR   OBJECTIVE:-  To perform the connections of the rear door of the car with different connections                       …

AIM:-performing geometry clean up and solid meshing or tetrahedral meshing of a given rear view mirror model as per given quality criteria.                                                 GIVEN QUALITY…

S.No  Quality Criteria  Value  1 Target/Average length   1 2 Minimum Length  0.5 3 Maximum Length  3 4 Aspect  3 5 Warpage 15 6 Skewness 45 7 Jacobian  0.7 8 Minimum Quad Angle  45 9 Maximum Quad Angle  135 10 Minimum  Tria Angle  30 11 Maximum Tria Angle  120 10 Tria Percentage  15 AIM:-to generate the mid surface of…

  AIM:-for the given component checking geometrical errors and meshing the model according to the given quality criteria. S.No  Quality Criteria  Value  1 Target/Average length       5 2 Minimum Length               2 3 Maximum Length              7 4 Aspect                             3 5 Warpage                     …