Week 3 - 2D meshing for sheet metal

aim :  Follow the below-mentioned quality criteria, mesh the component given below and assign thickness: Target Element Length = 5 Units S.N Quality Criteria  Value  1 Aspect Ratio  5 2 Skewness 45 3 Warping 15 4 Taper      0.5 5 Min. Length 2 Units 6 Max. Length 8 Units 7 Min angle Quad…

AIM: For this challenge, you will have to mesh the given geometry. Provided below are the quality parameters that you have to follow. Target Element size - 5 Units S.N Quality Criteria  Value  1 Aspect Ratio  5 2 Skewness 45 3 Warping 15 4 Taper      0.5 5 Min. Length 2 Units 6 Max.…

AIM:  Create a Teramesh for Housing component with the following quality criteria. TetraMesh Generation Method: 2D to 3D Conversion Elements sizes: Min- 2 Units, Target- 5 Units, Max- 7 Units  Tet collapse: 0.15 Housing Model   For the given model, Create a 3D Tetramesh with the following quality criteria.  TetraMesh Generation…

AIM: Follow the below-mentioned quality criteria, mesh the component given below and assign thickness: Target Element Length = 5 Units S.N Quality Criteria  Value  1 Aspect Ratio  5 2 Skewness 45 3 Warping 15 4 Taper      0.5 5 Min. Length 2 Units 6 Max. Length 8 Units 7 Min angle…

Aim: Mesh the Given component with the Size of 5 Units. Create 1D elements on the following component with given cross-section and DOF. procedure: import the model. obtain the midsurface using automid in surface option  on mid surface create a washer element  generate mesh using 5mm grid size  for generating…

AIM:For the given component, check for the geometrical errors and mesh with the given element Quality criteria. After meshing the component the thickness has to be assigned.  precedure :   import the geometry in the ansa. set cons resolution to 1. using faces new option close the geometry.  after closing…

AIM:For the given assembly, check for the geometrical errors and mesh with the given element Quality criteria. After meshing the component the thickness has to be assigned for mid surfaces. Use tetra elements to model non-uniform thickness components. Also, use Appropriate connections to connect the component.Use PBAR…

tool test is attached   

tool test are attached 

aim: to do connections in rear door handle =. procedure:  1) open the model in ansa. 2) create the property id for various components of door. 3) go to nastran deck select rbe 2 , apply rbe 2 to all the parts where bolts are needed, like hinge, hinge mounts , brackects . 4) for the hinge allow the rotation in z axis. and…

)AIM: For the given Plastic Bottle Cap model, check for the geometrical errors and take the mid surface by suitable mid surfacing techniques. PID and Thickness assignment has to be done for all the mid surfaces. Mesh the same with given element Quality criteria. objective: To extract manual mid-surface for the plastic…

AIM:For the given Hood model, Take the mid surface for all the components after checking the geometrical errors and mesh the mid surface with the given element Quality criteria objective: to get model fe of the sheet metal component using mid suraceing operations  procedure: 1) Import the geomery in ansa , set cons…

AIM: For the given Rear view mirror component, check for the geometrical errors and mesh the Surfaces with the given 2D element Quality criteria given maximum length 2mm average length 1 mm minimum length 0.5 mm. Use tetra elements to mesh the Volumes defined in the model and check for the below quality after Volume…