EXPLANATION:
1.i took the build signal from library with required input.
2.simulink converter is attached to it with problem solver.
3.controlled temp solver(S) is fixed to the terminal.mechanical refer is earth.
4.B terminal is fixed to thermister(T).
5.voltage sensor is fixed with battery w.r.t charges.
6.electrical refer is earth.
7.slope is attached to voltage with switch on other side.
8. 0 and 1 are given as off and on for fan.
9.slope is given to the switch.
10. finally i came upto here. after this one i am not able to get output.
so, stopped till now.
EXPLANATION:
1.First chosen the solenoid from library.
2.battery with pulse generator had been chosen.
3.connected them using PS converter and electrical reference is given below.
4.and on other side plunger terminal R is Ideal Tranlational Motion sensor.
5. to the sensor scope and scope1 is fixed to see the graph for velocity and its position to the respected terminals.
6.finally now C terminal is earth and run the programe .
7.output is shown in image.