Week 14 challenge

BUTTERFLY VALVE REPORT:

BUTTERFLY VALVES CAN ALSO BE USED IN AUTOMOBILE SYSTEMS.FOR INSTANCE YOU WILL FIND THE NBUTTERFLY VALVE INSIDE THE CARBUREATOR OF A CAR.IN THIS CASE THE VALVE IS USED TO CONTROL THE FLOW OF AIR TO THE CAR'S ENGINE.IT CAN PARTIALLY OPEN AND CLOSE TO REGULATE THE AMOUNT OF AIR PASSING THROUGH.BUTTERFLY VALVES ARE A FAMI9LY OF QUATER-TURN ROTATIONAL MOTION VALVES THAT ARE USED IN PIPELINE TO SHUT-OFF FLOW.IT IS OFTEN SAID THAT BUTTERFLY VALVES CAN BE USED TO REGULATE THE FLOW

• FIRST WE WANT TO MAKE THE ASSEMBLY OF BUTTERFLY VALVE FOR THAT WE BWANT TO ASSEMBLE ALL THE PARTS AND MAKE INTO SINGLE PARTS .WE WANT TO START IT WITH THE SHAFT AND ELLIPTICAL PLATE
• WE WANT TO MOVE THE PLATE TO NEAR THE SHAFT AFTER THAT USE ASSEMBLE CONSTRAIN TO CONSTRAIN THE TWO PARTS AND AFTER MAKE THE PART THE MOVE THE PART INTO THE BUTTERFLY VALVE BODY
• AND USE ASSEMBLY CONSTRAIN OPTION TO CONSTRAIN THE THREE COMPONENTS AND MAKE INTO A SINGLE COMPONENT
• AFTER THAT MOVE THE RETAINER PLATE AND ASSEMBLE THE PART TO THE BUUTERLY BODY VALVE BY THE ASSEMBLY CONSTRAIN COMMAND
• AFTER THAT HANDLE SAME LIKE THAT MOVE AND USE ASSEMBLY CONSTRAIN OPTION TO CONSTRAIN IT AFTER THAT USE NUT THE SAME PROCESS WE WANT TO REPEAT TO CONSTRAIN THE PROCESS
• AFTER FINISHING THE ASSEMBLE PARTS GO TO DRAFTING OPTION TO MAKE MAKE THE DATUM TARGET SYMBOLS AND GIVE DATUM TO THE SURFACE AFTER THAT GIVE THE FEATURE CO0NTROL FRAME TO THE SURFACE AND FEATURE OF THE SURFACE