Week 11:- 2D Detailing Challenge 2

OBJECTIVE:-

1. Create a 2D Drawing for each Clamp Unit with all child parts and also create a Child pard drawing for the same for the Fixture assembly created in challenge 8.

2. Create a 2D Drawing for each Pin Units drawings with all child parts and also create a Child pard drawing for the same for the Fixture assembly created in challenge 8.

INTRODUCTION:-

The fixture design after the 3D finishing process has to be done with 2D finishing before it is sent for manufacturing. All the dimensions of the fixture units and their child parts have to clearly mentioned in the drawing sheets. The detailing can be changed as per the requirement of the customer and company standards. GD&T must be used in order to reduce the cost of manufacturing.

All the views must be clearly visible and provided with dimensions in the drawing sheets.

I am using the first angle of projection for Drafting.

 

2D Detailing of the Clamp unit 1

It is saved as P001_Z01_ST01_01_05_CLAMP_UNIT_TYPE 01

 

The front view, bottom view, Top view, and right side view are shown for the clamp unit. The overall dimensions are provided also with the Isometric view of the Clamp Unit with all the subparts marked.

Detailing of the clamp Mylar

Detailing of the Rest Mylar

 

Detailing of L-block

 

Detailing of L-block-2

Detailing of Riser

Detailing of shims

2D Detailing of the Clamp unit 2

It is saved as P001_Z03_ST01_01_05_CLAMP_UNIT_TYPE 02

The front view, bottom view, Top view, and right side view are shown for the clamp unit. The overall dimensions are provided also with the Isometric view of the Clamp Unit with all the subparts marked.

 

pin unit

pin

 

refleter

shimes

T block

 

 

Detailing of clamp

 

 

 

 

Detailing  of  blade

 

 

Detailing of stopper

 

Detailing of DIAMOND PIN

pin connector

 

Detailing of  Block

Detailing of  Block

Detailing of  PIN

 

Detailing of  L Block

 

Detailing of  screw

Detailing of  riser

 

 

 

 CONCLUSION

Hence, the Clamp unit drawings with all the child parts and the Fix Pin Unit drawings with all child parts for the complete Fixture assembly were completed.