Week 8 - Challenge 2 - Switch Bezel Design

STEP 1 The interaction is crated direction in asketch byusing intersection option were creation by simply using intersectoin tool

step 2 the lines are drawn by taking the intersection lines are references. just make sure to select the two polints as a linse type

step 3 the two lines were drawn by simply selecting the two points

step 4 the tooling axies is created by using the line tool just make sure that to select the bisection option as alines type

step 5 bisecting lines are drawn by simply selecting the lines which are drawn above and the middle point

draft angle

usually the normal draft angle 3deg is provide on the part

providing the normal draft angle is easy and very economical

check the draft angle of the faces by clicking the option available on the toolbar the popup below the draft analyise tool bar shows the range of the draft angle of the face with the different colrs

3 deg- green

0 deg-sky

nev deg -red

draft angel is completed and get perfect value