Week 10 - Challenge 3 - Door Trim Lower with Engineering Features

Door Trim Lower with Engineering Features

Tooling axis : There is Two tooling axis was created on Door trim lower

Main tooling axis : Y component

Side tooling axis : X component

Class A : Input

Class B : 2.5 mm thick, Draft 0.5

Class C : 90 degree draft belong to "Class A surface"

Locater : Create the two located with the given Input.

Heat stakes : Create the Heat stakes wit the given input point Located.

Draft analysis : There is draft analysis was created on Door trim lower draft analysis

And I attached the Draft analysis snip image also.

Door trim lower Draft analaysis Report :

Direction

X : -0.00

Y : -1.00

Z : -0.00