Week 10 - Challenge 3 - Door Trim Lower with Engineering Features
Step:-CLASS A SURFACE
Now I'll be having a class surface with my hand.the next step is that we need to check in which side the component tooling axis is going to create for the line will be checking from existing axis.now i am going to check with X,Y,Z axis.we can able to see less than of y-axis from this axis.we can able to see all the surface.
Step:-
Create on dummy tooling axis for this y-axis direction.creating tooling axis .we need point and line for creating point and line.
Step:-
Draft analysis tool select the component then pick the component.we need to place it again we can check draft analysis clearing or not.
then i can able to see all the surface patches are clearing with our anaylsis.
Step:-CLASS B SURFACE
we have done for creating classes we have extracted then we have make on intersection between the two surfaces i have selected this side as my offset direction than i will be giving how much (mm) it should need to offset we need to use 2.5mm which is mentioned in your quession.
it is showing that while offsetting some of the surface patches are going to missing either.we can able to see only fillet patches are missing.creating B surface i am going to use different methodology and different types of tools.i am using tools BOUNDARY,BLEND,EXTRACT,MULTI EXTRACT,FILL,EXTRAPOL after we need to check whether our B surface is proper or not THEN FINALY JOIN.
Step:-CLASS C SURFACE
Creating C surface,we are going to use the sweep command for using draft direction.frist create the boundary then second type this is a line type.we are using because it is having two input.now we will be having two import one is the boundary onther one is a draft direction.now i can able to select the compass properly,then i can able to give three degree,draft click preview.creating a c surface,same like that, select the boundary curve and draft direction as my tooling axis.give ten degree for reference of it and select the compass outward properly,then select three fegree here.you can able to see the five (mm).sweep is not enough because it is having some vertical patches,both the side.so i will be giving here,maximum limit of 25 so that be getting the surface like this.you got your c surface as a single patch.we can able to join this for joining the class,A and C insert on geometrical set.I'll click ok.so that you will be getting the c properly.then final trim.
Step:-Door Trim
creating a door trim using extrude command.use an direction surface.next concept the c value or the intensection should be 40% of the thickness of the main component.and height of b surface should be 3 to 6mm from the b surface.fine so the thickness of component.it is 2.5mm and 40% iam going to see it. for the base 2.5*0.4=1 of wall thickness.we can do a draft analysis.
Step:-
FINALY FINISH THE COMPONENT.but image is not visiable so i could not draw the that 3 lock position