Week - 1 - Consistency of Units

Here's an example: Young's Modulus of steel is 210GPa which is input as 210e+9 in LS-DYNA as per SI unit system. However, if you use kg/mm/ms unit system, the input quantity will be 210. Thus the conversion factor is 10^-9.

But, how?

That's for you to find out in this assignment.

Value of the following measurements are given as follows:

MASS 1kg
LENGTH 1m
TIME 1s
FORCE 1N
STRESS 1Pa
ENERGY 1Nm
DENSITY 1Kg/m3
YOUNG'S Modulus 210GPa
Velocity 56.33KMPH
GRAVITY 9.8m/s2

Now, here are a few system of units:

Kg cm ms

Kg cm s

gm mm ms

kg m s

g cm s

g cm us

g mm s

ton mm s

slug ft s

kg mm s

g cm ms

kg mm ms

Write the given measurements in the above different system of units. Also, mention the conversion factors.

**The assignment should show detailed calculation for conversion from SI unit to gm/mm/ms unit system. For others only the answers in the form of a table is sufficient with the unit systems as rows and measured quantities as columns.**

Write your report here calculations written down on a piece of paper and uploaded as an Image will no be accepted.

All the answers should be in the form of a report. Only then it will be considered for Grading.

\

https://docs.google.com/spreadsheets/d/1uR9b2xpeL0dpCA-DeWYU-n8DYfnL5NhSZMnomSLF7kI/edit?usp=sharing