Project 1 - Wiper control system and Vehicle speed calculation for ABS using Wheel Speed sensor
Question1 - Wiper control system
AIM: To develop a Simulink/state flow model for the wiper control system based on the given conditions.
- If the density of the rain is low, then the wiper rotates at a low speed & the output signal should be 100rpm
- If the density of the rain is medium, then the wiper rotates with medium speed & the output signal should be 200rpm
- If the density of the rain is high, then the wiper rotates with high speed & the output signal should be 500rpm
SIMULINK MODEL FILE
SLDD FILE
REQUIREMENT TAGGING
APPS-> Requirement Manger-> Requirement Editor
MODEL ADVISOR –JMAAB COMPLIANCE REPORT
Fixed Point Tool
SLDV Design Error Detection Report
Functional Test Case MIL, SIL harness, Coverage Reports
MODEL IN LOOP
SOFTWARE IN LOOP
SLDV Test Generation Report
Auto CODE Generation Report
Polyspace Analysis Report
Test Manager Reports- Baseline & Back-to-Back Testing
Baseline Testing
Back-to-Back Testing
RESULT:
The Simulink model is verified and validated. All the reports generated are attached.
=============================================================================
Question2 - Vehicle Speed Calculation
AIM: To develop Simulink/state flow model for the vehicle speed calculation unit inside the ABS system.
(fl, fr, rl, and rr are the wheel speeds of the front left, front right, rear left, and rear right respectively).
SIMULINK MODEL FILE
SLDD FILE
REQUIREMENT TAGGING REPORT
MODEL ADVISOR –JMAAB COMPLIANCE REPORT
Fixed Point Tool
SLDV Design Error Detection Report
Functional Test Case MIL, SIL harness, Coverage Reports
MODEL IN LOOP
SOFTWARE IN LOOP
SLDV Test Generation Report
Auto CODE Generation Report
Polyspace Analysis Report
Test Manager Reports- Baseline & Back-to-Back Testing
Baseline Testing
Back-to-Back Testing
RESULT:
The Simulink model is verified and validated. All the reports generated are attached.