Project 1

Project 1:

Making of the seat back:

In this case, we've got provided with a dump solid of the seat back and headrest so we'll have to create sto then we'll have to create the solid foam so for that I extracted the surfaces of the dump solid and repaired some damages over the surfaces then I've created sto

1.SEAT_LOWER_CREATING_

Creating H-point:

To create the H-point I've created a point over the curve then I've created lines from that point in 40 mm length and 20 mm height

After that i created multisection surface for the back side

Making of wings(BOLSTERS):

So in this case I've followed a different type of approach which contrast to other approach shown in the video, So, what am i done is I extracted the surfaces of the BOLSTER'S.

I Make the sweep command to create the bolster and offset it and I trimmed the bolster using the Trim command.

Then I begin to create the top and bottom surfaces first I extracted the top surface then took a boundary and extrapolated then I trimmed them together and the same thing I've done for the bottom surface as well.

Making of seat lower part:

Then whatever methods I followed for creating seat upper part same thing I applied for the seat lower part as well

STO:

Surface body:

Solid foam:

Solid foam:

Making a solid foam from Unproper sto:

Given data:

making of the top and side surfaces using the sweep command.