Project 1

Downloaded all required data from given links. Converted and saved at desired location in CATIA V5.

• Connector DefinationAll connectors with given specification defined as electrical components. Bundle and connector connection points are given to each connector as well as cavity connection also defined.
• Protective Covering and Catalogue creationCreated COT Tubes with different diameters and saved in catalogue.
• 
• Channel AssemblyWith given data, channel is created and creation of harness with bundle connection done.Top cover is imported and positioned and saved.
• 
• Engine Context AssemblyEngine Context assembly is created inside main file and imported all necessary components. Connectors are imported in assembly and positioned using Snap and manupalation commands. Switched to harness assembly workbench. Geometrical bundle defined and branchables started to route. All connectors are used to route the harness and specified points as per requirements. Finally protective coverings are applied on wiring harness and given extrimity as per safety. Diameters are given by area near the harness bundle occurs. Finally saved the assembly at desired location.
• 
• Flattening

Context assembly imported inside flattening workbench and flattening parameters defined. Started flattening and repositioned connectors as XY plane orientation.Using Rotate, roll commands harness and connectors placed in good manner

• Drawing Creation

Flattened assembly extracted inside dwawing sheet and given title block.

• Final Product

Finally assembly is well settled for submission and all files compressed in a zip file.