Project 1

Good Afternoon Sir,

I am submitting my first project and I have created the mold block with core and cavity surface as well as core cavity block by using the assembly feature.

After making a core and cavity surface we have to create two sliders on both sides for that slot which is displaying in the model after that I will create a mold block for that component.

in which I have especially used mold tool for creating mold block. there is some following step for creating complete mold desgin for a given model.........

1. Draft Analysis (analyze the draft angle and find their required draft which was decided to core and cavity)

2. Scale (using shrinkage allowance according to desired material)

3. Parting line (creating a parting line for separation of core and cavity)

4. Shut-off surface (fully defined for creating a parting surface)

5. Parting surface ( using sketch tool and surface planer tool and then surface trim command for creating parting surface)

6. Body-copy/move (using editing tool parting surface for core and cavity separately)

7. Surface knit for core and cavity by using the surface tool.

8. Boss Extrude command for creating mold block

9. Again use the Body-Copy/Move command for creating separate mold blocks for care and cavity respectively.

10.Surface knit for core mold block

11. Surface knit for cavity mold block.

12. For creating each slider, use split command and direct editing feature command.

13. after creation of both slider completely then go for the creating washer used in guide way to support to & fro motion for slider. In this part I also use direct editing and extrude feature of solidworks.

14. Atlast I have created ejector pin for eject the table fan base model from die by the using of core command in mold tool feature, Create some relief for ejector pin according to standard requirment of ejection of part.

Thanking You,