Final Project: Electric Rickshaw modelling

MATLAB modelling of E-Rickshaw:

Basic Info:
Rear wheel drive using PM brushed typr motor

To show temperature rise in motor and controller for 100km at constant speed of 45kmph. So the time required to simulate is (100/45)*60*60=8000 sec

Three standard driving cycle taken as

1) Drive cycle source FTP75

2) Constant Block giving 45kmph

3) signal Builder block

Using built-in block for vehicle body, controller(H-Bridge )

The objective is to measure the temperature of the motor and H-Bridge controller, while the vehicle runs at constant at 45kmph for 100km.

So the temperature at the end of 100km run is 43.75degC for motor and 31.25 degC for controller temperature.