Fender Design - Wheel Arch Challenge

fender wheel Arc desgin in europin standard .

Main function is to prevent the sand,mud,water or other liquids and other small road spray being thrown by air into the engine or pedestrain compartment.

Material suggested .

aluminium, plastics,magnesium,and fiber materials.

types.

full bumper .

old model cars we can find this type .it covers the full area at fronter portion.

half bumper .

modied bomper with the reduction in the sheet metal materials and desgined to produce with the blank.

From other nations forms which the length L value compared with 5 sections which is SA SB SC SD SE.

Which the distance is to be above 10mm for different sections which is to be satisfy.

for length are calculations we consider European standards because it satisfies all 3 norms.

process proceding for European norms.

• Make a vertical line centre at 90.
• With regading SA to SB front and create 50 rearward for sc.
• SE is creating line 150MM for creating SD make center point for SC *SE.

The distance between fender arc and wheel base is to be measured from top view.

Observation table .

Section clerance measured test result

SA. Fail. =. 9.9490.

SB. Pass. =. 10.000.

SC. Fail. =. 2.8875.

SD. Fail. =. 0.1139

SE. Fail. =. 5.9973.

conclusion.

. The conclusion for wheel Arc did not satisfy the European standards only SB section is to pass the test .

Since the test falied to achieve the norms .so have to make suggestions for styling team to change the desgin according to suggestions.

section SA SB SC SD SE failed to achive norms.