Fender Design Challenge
Objective:
The main objective of these projects is to design a front fender from given skin data and the master section provided with drip, bumper, A-pillar, splash, and sill mounting areas in NX cad.
Fender definition:
the fender is called the wing. This may refer to either the front or rear fenders. However, in modern unibody vehicles, rear fenders may also be called quarter panels.The guard over the wheel of a motor vehicle of locomotives and streetcars to lessen injury to animals or pedestrians in case of collision.
Mounting area in the fender
- Drip area
- Sill mounting
- Bumper mounting
- A pillar mounting
- Splash cover mounting
Drip Area:
the area defined by the outermost circumference of a tree canopy where water drips from and onto the ground
Sill mounting:
A part of the car's supporting structure.It is found at the bottom of the fender. They are exposed to corrosion and mechanical damage. They may also be deformed while the car is lifted for service purposes.
Bumper mounting:
Bumper means any front, lower, outer structures of a vehicle, including attachments which are intended to give protection to a vehicle when involved in a high speed frontal collision with another vehicle.
A-pillar Mountings:
Either one of two support posts that are positioned on either side of the windshield of a vehicle and connect the roof to the body.
Splash cover mountings:
A flap suspended behind a rear wheel to prevent tire splash from muddying windshields of following vehicles.
OVERALL DESIGN VIEW OF FENDER
Conclusion:
Thus the Drip area, A-pillar, Sill area, Bumper mounting, Splash mounting, C-mounting are designed on the fender as per the master section by using NX Cad.