Fender Design Challenge
Aim :
To create the design of Font Fender with Drip Area, Sill mount Area, Bumper mount Area, A pillar Area according to the Engineering Standards by using NX.
Front Fender :
Mudguard is the part of an automobile body that frames a wheel well (the fender underside). Its primary purpose is to prevent sand, mud, rocks, liquids, and other road spray from being thrown into the air by the rotating tire. Fenders are typically rigid and can be damaged by contact with the road surface.
Fender are the complex sheet of metal covering the front and the rear wheels of your car
Car fenders not just add style to your car but also act as a protective shield for the body of the car.
Types of Fender :
- Full bumper type
- Half bumper type
Uses of Car Fenders :
- Fenders limit the exposure of your car’s body and engine to external elements that are harmful.
- Fenders flares are attached to ensure that both the body and engine have minimal contact with corrosive elements.
- Fenders provide safety to the driver and the passengers at the time of accidents or collisions. They are manufactured in a way to provide bend during front and side collisions.
- Fenders are designed to avoid wind resistance and make your car more aerodynamic.
Commands Used :
- Curve on Surface
- Trim Sheet
- Law Extension
- Face Blend
- Bridge Curve
- Emboss
- Edge Blend
- Extend Sheet
- Dart
- Project curve on Surface
Master Section :
Bumper mount Area :
Sill mount Area :
Splash cover mount region :
Drip Area :
A Pillar :
Isometric :
Result :
Thus the all mounting regions on front fender have been designed as per Engineering Standards by using NX