Fender Design
- extract the surface of class A surface
- offeset the edge (curve) of the extracted surface by using offset curve in face as showing in fig.
- create curve on faces where we need to law extenction.
- trim the sheet where we created curve by curve on surface.
- law extend at the trimed surface by using law extension.
- line to be created on both side of the extended surfacce by using curve on surface .
- trim the extended surface using trim sheet with reference of curve on surface.
- datum plane is to be created on surface as shown in above fig.
- curve to be created on the surface.
- trim the surface where curves is created using trim sheet.
- law extend the trimed surface as shown in fig.
- created sketch on the law extended surface as shown in fig.
- create emboss on law extended surface which reference to sketch drawn on the law extended surface .
- create the law extenction on surface at required position on the class A surface.
- creare the sketechs and emboss on the law extended surfaces as shown in above figs.
- thicken the final class A surface for 0.75mm.