Fender Design

firstly we get the input file from the challenge we get input files and we start to work on it

we create the first offset of the outer profile and start working on it. we create the drip area first we made the profile and made the extend the sheet and then made the law extension at the desire the desire angle according to the mastersection we made the low extension again according to the master section again and again . then we have made edge fillet of the part and made the clamping hole to mount we made the slot with emboss and we made the emboss offset to the datum and we have made the same procedure for the a pillar and we have also made the boundary on sheet firstly we have made the curve on surface with G1 profile as a outer end of the line and we have also made the trim according to the profile which is created on surface and we use trim surface to create the clamping according to the mastwer section and we have made the final part ready for the draft analysis

i have attach all the files to this files