Challenge

Fender Design

UUmashankar K15 Sept 2022

Aim :-

Follow the given Master section to create the Drip Area using Siemens NX Cad.

Objective :-

To design a model with necessary mount and a surface in the class.

Mount :-

1. A Pillar

2. Bumper

3. Sill

4. Cowl

5. Drip

Introduction :-

Fender Design :-

It is a american term of the part automobile motorcycle other vehicle body that a wheel well its primary purpose to prevent sand, mud, rocks, liquids and other road spray. Thrown into typically rigid and can be damaged by contact with the road wurface, Fender is the part of a car protect and frames wheel and keeps mud from splash.

Types of fender :-

1. Full Bumper

2.Half Bumper

Procedure :-

Fender design :-

In a input received class A srface check and the surface to proceed. We removed the extra flange and make some possible oout using curve on surface command, Now we start making mount section. The first mounting we created is drip area mounting we extend the surface using law extension then created emboss on it. We also created drip area with help of draw.

After create drip mounting we created sill mounting, In this we extended the surface using law extension the draw sketch and emboss it in mounting we also created stress relief area here so that the stress want accumulated certain points. We created the bumper mounting by extending the surface making emboss on it. We also smoothen the edges of mounting using bridge curve. Baffle mounting we simply extended surface made the sketch and trim the sheet. Lastly we created A pillar mounting in this we extended surface created sketch made the emboss and then done the trim sheet for hole.