Drafting of various geometries using Chamfer, Fillet tool in AutoCad

Aim : Drafting of various geometries using Chamfer, Fillet tool in AutoCad

Procedure :

1. Drawing 1 - Decimal

- By using the unit command it was set to Decimals.

- By using line command the Particalura dimensions were given in the command libe and the line was drawn.

- For the line with angle the command was used as eg: @2.12<90 and enter

- For the circle the centre point was assumed by using the reference and the Line command.

- By using the command Circle, diameter the circle was been drawn.

2. Drawing 2 - Architectural

- By using the unit command dimension was set to Architecture

- Then by using the Line command the horizontal and Verical Lines were drawn.

- For the Line with particular angle the coomand was used as eg: @3<135 and enter.

3. Drawing 3 - Engineering

- By using the unit command dimension was set to Engineering

- By using the line command the Line with particular dimensions were drawn.

- For the Line with particular angle the coomand was used as eg: @3<135 and enter.

4. Drawing 4

- By using the unit command dimension was set to Decimal

- Here the Orthomode was kept on.

- And by refering the dimensions & line command the Drawing was completed

5. Drawing 5

- By using the unit command dimension was set to Decimal

- By refering the Dimensions and vertical , horizontal line, the drawing was been partially completed.

- For the circle the centre point was reffered using the Line command.

- After that using the Circle, Diameter command the circle was drawn

- After drawing the circle, the lines drawn for the centre point was been trimmed.

6. Drawing - 6

- Use the line command & given reffered dimensions.

- By using the offset command the further line was drawn and completed.

7. Drawing - 7

- The fiven radius was been set by using the fillet command.

- The rectangles given were drawn by using the Line command using the given reffered dimensions.

- For the circles the centre point was taken by using the line command

- Then by using the Circle, Diameter the circle was drawn and then the lines drawn for circle centre were trimmed later.

8. Drawing - 8

- By using the line command the Line was drawn of a given dimension.

- Then by using the Circle,dimension and Circle, Radius the circle of given radius and diameter were drawn.

- And the drawing was complete by joining the lines with a particular given circle.

9. Drawing - 9

- The line was drawn using the line command of given dimension.

- The drawing was completed using the command Circle, tan - tan radius.

- And hence the drawing was been completed.

10. Drawing - 10

- By using Line command the square of particular dimension was drawing

- Then the offset was been given and thereffered line were joined.

- And according to the drawing the referred lines were trimmed by using the trim command.

Conclusion - Hence by using the following commands the challenge was been completed.