Creating Kitchen layout, Hatching of Architectural elements and sectional view of an Industrial Building in AutoCad

1.AIM:To create the layouts of the Kitchen and provide hatches pattern.

Procedure:

• First ofall we have to set the units by usinh un +enter in command box.
• Now we use mm in scale,Then we have to create a rectangle horizontal distance is 4730 mm dia and then vertical distance is 3630 mm .
• The outter wall thick ness is 70mm of both horizontal and vertical direction of the line.
• Then offset the downward of line at the distace is 600mm ,Then off the distance that the required amount of spacing given in the question which on diagram.
• Now same process on upwards horizontal line is same but the fridge distance is 1000mm and the microwave oven is differ the distance then the remaining all are set the line by using offset command .
• Then using text command name the area of the place and the product at the text height is 5 and then using offset command offset the downward line direction of upward line.
• That is 600 and 700 mm ,then use line command to create box the using fillet toll fillet the top edge of the boxs.
• By using h + enter is HATCHING we hilighted the outter wall surfaces.
• Finally save the drawing by using Ctrl+S or file option.

DIAGRAM:

RESULT:By using AutoCad Sofware we designed the layouts of the Kitchen and provided the hatches pattern.

2.AIM:To create a the elevation of the plan created in the Challenges 7 and apply proper hatch in the walls, doors, windows, and other architectural elements.

PROCEDURE:

• Now we have to change the scale as feet and then,Draw the ground level .
• now increse the height of 12 feets and the the column size is 0.45 inches and then 0.9 inches of columns are presented hear.
• By using line,offsett and arc toll we have created the windows and then Balckeny hear.
• Now extend the left side of the wall as distance of the line is 2 feets and then draw upwards distance is 0.5 inches and then turn off ortho mode and draw the inclined line.
• Same process on right side of the outter wall surfsce which is presented in right side direction.
• Now top of the elevation we have to draw the entrance of the top floor ,now the height is 12 feet as same as beow .
• Then using rectangle command draw the entrance of the block.
• Then again offset that will created by drawing as designs of top surface on the elevation.
• Finally save the command by using Ctrl+S or File same option.

DIAGRAM:

RESULT:By using AutoCad we created that the elevation of the plan created in the Challenges 7 and apply proper hatch in the walls, doors, windows, and other architectural elements.

3.AIM:To create the section view of an industrial building as shown in Figure.

Procedure:

• Again we have to change the scale as mm on units,Then draw a line at the distance is 15000mm .
• Offset the line distance is 5850mm and then we have to and then using offset tool offset the outter surface of the wall now using dimension mesure the the distance as inner part of the diagram .
• Now use the hatch tool and hatch the specific points.
• Using Singel and Multi Text name the area of the place and then draw the inner portion of the beam and draw the inclined line as shown as z axis line of the beam designs.
• By using outter side of the line will change the type of the line .
• After completing the diagram we have to save by using Ctrl+S or File same option.

DIAGRAM:

RESULT:By using AutoCad Software we created the section view of an industrial building as shown in Figure.